Bonding In a Post With Simplicity Dental Adhesive BONDING IN A POST After rinsing the preparation, dry the surface for at least 3 seconds with dried compressed air. An appropriately sized paper point(s) is inserted into the canal to remove any remaining moisture. A drop of Simplicity® 1 is dispensed into one well of the small white plastic holding tray. Using a bristle brush, Simplicity® 1 solution is applied to the canal. It is allowed to dwell for 5 seconds. If there is any significant pooling of the Simplicity® 1 it should be blotted away. The prep should not be allowed to dry. (If the core is to be bonded at the same time, apply Simplicity® 1 to the rest of the prep as well.) Dispense a drop of Simplicity® 2 into the other well. Using a clean bristle brush tip, immediately apply 3 full brushes of Simplicity® 2 into the canal space (and the rest of the prep if indicated). The canal space is dried for at least 5 seconds. An appropriately sized paper point is inserted into the canal to remove any excess solvent. The canal is dried again for 5 seconds. The adhesive is light-cured for 20 seconds aiming the light guide directly into the canal parallel to the post space. Sandblast post if it is metal.
Coat the post with a layer of Simplicity® 2 and light-cure 10 seconds. Inject anchor® The Complete Core Build Up Material (or a material of your choice) into the canal. Seat post into canal. If a dual-cure resin cement is used, the outer surface may be light-cured at this time and the rest of the core built up. STORAGE Protect from sunlight and maintain temperatures between (0°C/32°F and 30°C/85°F). Refrigeration when not in use and refrigeration of unopened bottles is recommended. This product is subject to evaporation, keep bottles tightly capped. See individual component labels for specific expiration dates. CAUTIONS Avoid splashing into the eyes. If it comes into contact with the eyes, flush with copious amounts of water and seek medical attention. Un-polymerized resins may cause skin sensitization to susceptible persons. In case of contact with the skin, wash thoroughly with soap and water. WARRANTY Apex Dental Materials, Inc. recognizes its responsibility to replace products if proven to be defective. Apex Dental Materials, Inc. does not accept liability for any damage or loss, either direct or consequential, stemming from the use of or inability to use the products described. Before using, it is the responsibility of the user to determine the suitability of the product for its intended use. The user assumes all risk and liability in connection therewith. CAUTION: U.S Federal law restricts this device to sale by or on the order of a dental professional
Other Products Used In This
Technique
|