|
 Although
it is not critical to the success of SURPASS™, it is recommended that
the preparation be cleaned with isopropyl alcohol on a cotton pellet
and rinsed with water prior to beginning the bonding protocol. Pumicing
or gentle particle abrasion of enamel is also recommended. Rinse the
preparation thoroughly and remove all visible water by drying the surface
for approximately 5 seconds with dried compressed air. Dispense a drop
of SURPASS™ 1 into one cavity of the enclosed mixing well. Using the
proper color-coded brush, apply SURPASS™ 1 to the entire cavity preparation
and the surrounding tooth structure, agitating briskly for at least
ten seconds. DO NOT DRY SURPASS™ 1 Dispense a drop of SURPASS™ 2 into
another cavity of the mixing well. Using the proper color-coded brush
apply three brushfuls of SURPASS™ 2 to the entire cavity preparation,
dabbing each brushful to help distribute as much of the primer as possible.
Dry the primed surface with dried compressed air for at least ten seconds
with the air syringe tip as close as possible to the surface. DRY SURPASS™
2 THOROUGHLY Dispense a drop of SURPASS™ 3 into another cavity of the
mixing well. Using the proper color-coded brush apply a thin layer of
SURPASS™ 3 to the entire cavity surface. Light-activate for ten seconds.
SURPASS™ can be activated with any dental activation light. Continue
restorative procedure with material of choice. Follow manufacturer’s
instructions for all restorative materials. NOTE: For indirect restorations,
air-thin SURPASS™ 3 sufficiently to allow seating of the restoration
and light-activate. NOTE: Deciduous teeth are treated in the same manner
as permanent teeth. NOTE: SURPASS™ 1 should be agitated for 15 seconds
on uncut enamel. NOTE: SURPASS™ is always light-cured before placing
veneers and bonded crowns. To Order Please Call 1-888-277-2335
|
MSDS